Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Error while trying to restart the analysis

Status
Not open for further replies.

hamadadf

Civil/Environmental
Mar 3, 2006
62
When i try to restart my analysis, i get this error message and i don;t understand why.
***ERROR: Features such as new nodes/elements, IMPORT, SYMMETRIC MODEL
GENERATION, MAP SOLUTION are detected in a continuation analysis
where the original model is defined in terms of an assembly of part
instances. This is not allowed.

Note that i didn't change anything from the original input file. Just modified something in a subsequant step and i don't believe that is the reson.
 
Replies continue below

Recommended for you

hamadadf
Any change made in the Keyword will not be considered in the Restart>
 
even if i was changing in the next step?
 
If you want to use *model change in restart, it has to be used in the step before the restart step too in the inital analysis.

Try add this in the first step and re-run the inital FEA.

*model change, Activate

Hope that should slove your problem

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor