Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

error with Reference Dimension Parentheses macro

Thread starter jackk
Start date Nov 20, 2020

Status: Not open for further replies.

Nov 20, 2020

jackk

Mechanical

I copied Ricky's macro from this post and pasted it into a new macro I created.

https://www.eng-tips.com/viewthread.cfm?qid=363662

but when I run this macro I get a error message about a scripting error 1002 (see attached image). Any suggestions on how to make it work? (I'm just a drafter - not a macro guru)

I've used the macro in the past and it was a big timesaver. Just started a new job, and would like to use this macro again.

Running CATIA Version 5-6 Release 2019

thanks