Closius
Mechanical
- Dec 29, 2014
- 3
Does anybody use ESI Sysweld?
I would like to know some information about following questions:
1) The accuracy of calculating microstructure of metal (and stress) after welding and post-heating. Does Sysweld calculate a good results or bad?
2) What about an user interface of Sysweld? Is it hard to work with Sysweld (in comparison with the classic Ansys for example)?
4) Is it possible to add a new material properties into Sysweld? Is it hard or not?
Best regards,
Anton.
I would like to know some information about following questions:
1) The accuracy of calculating microstructure of metal (and stress) after welding and post-heating. Does Sysweld calculate a good results or bad?
2) What about an user interface of Sysweld? Is it hard to work with Sysweld (in comparison with the classic Ansys for example)?
4) Is it possible to add a new material properties into Sysweld? Is it hard or not?
Best regards,
Anton.