NTHI
Structural
- Oct 2, 2023
- 1
thread801-321954
Just to share in case someone is looking into how to avaoid load transfer into bracings when area loads are used in Etabs.
I found above thread (thread801-321954) but it is not possible based on above.
But try following.
Select the bracings
Go to Assign >> Frame >> Select Frame Floor Meshing Options
Select "Do not include Seleceted frame objects in mesh"
Just to share in case someone is looking into how to avaoid load transfer into bracings when area loads are used in Etabs.
I found above thread (thread801-321954) but it is not possible based on above.
But try following.
Select the bracings
Go to Assign >> Frame >> Select Frame Floor Meshing Options
Select "Do not include Seleceted frame objects in mesh"