May 7, 2014 #1 caruana Automotive Jun 23, 2003 37 0 0 MT Hello Is it possible to export or save as an assembly and create an image file (jpg) of each member of the assembly? Thanks.
Hello Is it possible to export or save as an assembly and create an image file (jpg) of each member of the assembly? Thanks.
May 9, 2014 #2 looslib Mechanical Jul 9, 2001 4,204 0 0 US What version of software are you using? Not that it matters becasue you cannot do that without some custom programming. If you run Windchill, then a check-in will generate images for each file in your assembly in ProductView/CreoView, if you have it set to do that. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli Upvote 0 Downvote
What version of software are you using? Not that it matters becasue you cannot do that without some custom programming. If you run Windchill, then a check-in will generate images for each file in your assembly in ProductView/CreoView, if you have it set to do that. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli
May 9, 2014 Thread starter #3 caruana Automotive Jun 23, 2003 37 0 0 MT Hi We are still on Wildfire 4 and Windchill 8. Thanks Upvote 0 Downvote