Export to spreadsheet in NX5

[scope63]

i am having trouble to export my assembly to a spreadsheet.
i do have the preferences set to excel and also in excel have the "add-in's" set to ug. when exporting i get this error message "failed to set excel running". i have sent this to GTAC but have yet to get an answer. has any one encounter this and solved this issue?

Scott Copeland
Mould Designer
G-Mag International Inc

http://www.g-mag.ca

 

[looslib]

What version of Excel?

When asking questions about software interaction, it helps to know all the information.

Does Excel work as a Family Table editor for you?
Can you create a drafting table with Excel in NX5?



"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli

 

[scope63]

i had office 2007 and have had no luck so i uninstalled and installed office 2003, same thing. i have tried also to do what you have asked about editing a table with excel. no luck
same error message appears " failed to set excel running"

Scott Copeland
Mould Designer
G-Mag International Inc

http://www.g-mag.ca

 

[looslib]

OK, that is telling me that the uga.xls (I think that is it) is not installing properly in your Excel folder.
Now that you have 2003 installed, try to do a repair install on NX5.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli