Jun 15, 2007 #1 brewmaster Automotive Sep 12, 2005 3 Is there a way to export various lengths of ejector pins that have been split to a chart on a drawing?
Is there a way to export various lengths of ejector pins that have been split to a chart on a drawing?
Jun 19, 2007 #2 solid7 Mechanical Jun 7, 2005 1,403 Are they on a design table, or at least all in the same model? ----------------------------------------------------------- Catia Design|Catia Design News|Catia V5 blog Upvote 0 Downvote
Are they on a design table, or at least all in the same model? ----------------------------------------------------------- Catia Design|Catia Design News|Catia V5 blog
Jun 19, 2007 Thread starter #3 brewmaster Automotive Sep 12, 2005 3 Yes they are all in the model and have individual names. Upvote 0 Downvote
Jun 19, 2007 #4 solid7 Mechanical Jun 7, 2005 1,403 Make a design table with the desired parameters. (like length) You can then link it to the spreadsheet on the face of your drawing. ----------------------------------------------------------- Catia Design|Catia Design News|Catia V5 blog Upvote 0 Downvote
Make a design table with the desired parameters. (like length) You can then link it to the spreadsheet on the face of your drawing. ----------------------------------------------------------- Catia Design|Catia Design News|Catia V5 blog
Aug 2, 2007 Thread starter #5 brewmaster Automotive Sep 12, 2005 3 SURFACE NORMALS Is there a way to make surface normals visable in V5 GSD? Upvote 0 Downvote
Aug 3, 2007 #6 DBezaire Automotive Feb 28, 2006 962 Surface normals at all times, turn off Tools - options - display - performance - enable two side lighting. Normal side will be bright. Regards, Derek Upvote 0 Downvote
Surface normals at all times, turn off Tools - options - display - performance - enable two side lighting. Normal side will be bright. Regards, Derek
