exporting from catia v5 to nx 7.5

[dwood]

Hello Everyone,
I am trying to export catia v5 models to NX 7.5. I believe this should be very simple. If someone can give me a simple step by step solution it would be greatly appreciated

 

[ferdo]

You can use a neutral format (depending on how do you want to import in NX and also depend on what license you have in CATIA) or a specific software (like OKINO for example or others).

Regards
Fernando

https://picasaweb.google.com/102257836106335725208

https://picasaweb.google.com/103462806772634246699/

 

[bankst]

Your best bet would be to export from Catia as a step or iges file and then import that file type in NX.

I know there are a variety of different Catia to NX translators that can bring different amounts of information over to NX but they vary in cost and some are very expensive.

Tim Banks
Application Engineer
VMH International
NX 8.5 / Solid Edge ST6

 

[nithink]

Check whether you have Catia translator license in NX , if available you can directly open the Cat product or Cat part [Drawings won't open even with license]

If not use STEP conversion in Catia and then open in NX.

Nx 7.5.5.4

Teamcenter 8