cooke1m
Mechanical
- Jan 21, 2005
- 1
Is anyone else experiencing difficulties with exporting Iges assemblies from Pro E Wildfire 2 into Unigraphics version NX3.
The export all levels feature within Pro E works and the iges files read back into Pro E as assemblies with all the correct levels.
However in Unigraphics the individual parts are ok but the assemblies come in corrupted and will not load. I tried exporting surfaces and solids with the same result.
At the moment we're at the point of is it Pro Engineer fault or Unigraphics. So much for data transfer compatibility
Anyone been through this before ?
The export all levels feature within Pro E works and the iges files read back into Pro E as assemblies with all the correct levels.
However in Unigraphics the individual parts are ok but the assemblies come in corrupted and will not load. I tried exporting surfaces and solids with the same result.
At the moment we're at the point of is it Pro Engineer fault or Unigraphics. So much for data transfer compatibility
Anyone been through this before ?