Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Exporting into Word file (ends of each line dissapearing!)

Status
Not open for further replies.

GalileoG

Structural
Feb 17, 2007
467
Hello all,

When I export my MathCAD file into Word, the ends of each line mysteriously dissapears (for example, 500mm will become 500mn, the other half of the m dissapears) What could cause this and how I can fix it? Thanks!
 
Replies continue below

Recommended for you

Is this font dependent?. I have had problems where built in fonts are not the same size as the display/print fonts so they don't fit the display/print space. [Arial was aparticular problem]

If it persists and is in V14 then report it on the V14 bug page of the Collaboratory (under Help -> User Forums)

Philip

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor