Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Exporting the result as 3D Model (step, or something else)

Status
Not open for further replies.
Masterarbeiter

Masterarbeiter

Student
Jan 26, 2022
6
Hi,

i need to use the design result from a topology optimization for a printing process.
Is there any way i could achieve that in Abaqus?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
There is a built-in option for that. Check the documentation chapter "Extracting a smoothed mesh".
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Achrafbno
  • Locked
  • Question
How to model the deck in a way to interact with the 3D beams?
Replies
2
Views
121
rb1957
rb1957
govindadumaru
  • Question
Error in load assignment in RISA 3d
Replies
3
Views
2K
BulbTheBuilder
BulbTheBuilder
olivel
  • Locked
  • Question
The difference between 3D scanner light sources
Replies
2
Views
104
drawoh
drawoh
Alvin Lin
  • Locked
  • Question
Confused on the use of poisson strain gauge configurations (half-bridge and full bridge) as well as
Replies
2
Views
133
rb1957
rb1957
PSRani
  • Locked
  • Question
Direct cyclic step in ABAQUS
Replies
4
Views
114
PSRani
PSRani

Part and Inventory Search

Sponsor

Back
Top Bottom