Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Extracting flat patterns/templates from model

Status
Not open for further replies.
Joblack

Joblack

Marine/Ocean
Jun 7, 2004
61
What is the best and easiest method of extracting flat patterns/templates for NC router cutting from a model/part and into Generative Drafting so as we can then send off to NC job shop or have plotted full size for the shop floor - using ym1 module. Note these templates are flat in the model and do not need to be un-rolled.
 
Status
Not open for further replies.

Similar threads

sri91
  • Question
CD5 Templates
Replies
0
Views
811
sri91
sri91
jzecha
  • Locked
  • Question
Error Extracting Surfaces from a Search
Replies
8
Views
104
jzecha
jzecha
reutov_tv
  • Locked
  • Question
Creating new parts and assemblies from templates
Replies
1
Views
75
itsmyjob
itsmyjob
O
  • Question
Abaqus2024 - Duplicate elements in model
Replies
0
Views
425
Old_Ironfighter
O
LeoVyc
  • Locked
  • Question
Equal holes from part recognition
Replies
1
Views
129
Little Cthulhu
Little Cthulhu

Part and Inventory Search

Sponsor

Back
Top Bottom