Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Extremely short runner lengths on FI application

Status
Not open for further replies.

ZoRG

Automotive
Jan 8, 2003
124
Hi

I am busy playing with a few inlet manifold designs, and am wondering what would happen if you make the runners really short, 1" or so, and have the injectors sit inside the plenum?
All manufacturing aspects aside, what would happen, would the car be really dead at the bottom end?

The engine setup is:

Honda B16A Vtec engine 1.7L
83mm bore, 9:1 Static CR
77mm stroke

Turbo is a Garrett GT35R, usual spool is around 14.7psi @ 5000-5500rpm, but the engine is being built to handle around 11000rpm or maybe a bit more.
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor