Sep 21, 2004 #1 mrainey Industrial Jun 22, 2002 225 Get a load of this. End mills under .0005 diameter! http://www.pmtnow.com/ Manufacturing Freeware and Shareware http://mrainey.freeservers.com
Get a load of this. End mills under .0005 diameter! http://www.pmtnow.com/ Manufacturing Freeware and Shareware http://mrainey.freeservers.com
Sep 24, 2004 #2 jbel Mechanical Jun 9, 2003 109 We cut 45 Rc H13 with 0.02" diameter ball mills and I thought it was pretty hot stuff. Oh well back to the drawing board. That 0.0004 end mill blows my mind!!!!!! Mrainey, I use your ME Consultant software and it is very good. Thanks you for doing all that hard work and then sharing it for free. Upvote 0 Downvote
We cut 45 Rc H13 with 0.02" diameter ball mills and I thought it was pretty hot stuff. Oh well back to the drawing board. That 0.0004 end mill blows my mind!!!!!! Mrainey, I use your ME Consultant software and it is very good. Thanks you for doing all that hard work and then sharing it for free.
Sep 24, 2004 Thread starter #3 mrainey Industrial Jun 22, 2002 225 You're welcome! Manufacturing Freeware and Shareware http://mrainey.freeservers.com Upvote 0 Downvote
![[thumbsup]](/data/assets/smilies/thumbsup.gif "[thumbsup] [thumbsup]")
