Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Extruded cut in an assembly

Status
Not open for further replies.

SrGilberto

Mechanical
Joined
Oct 13, 2004
Messages
132
Location
US
I created an extruded cut in an assembly (top assy). I want the cut to only intersect 1 part. When I edit the definition there is a parts bin that pops up when I click on the "Intersect" tab that shows the possible intersecting parts. When I highlight one of the parts and then right-click it there is an option to "remove" it (along with "information"). However, the "remove" selection is faded out and I cannot click it. I clicked on every part in the bin and I cannot select remove on any of them.

Here's the question: Why is the "remove" selection faded out and un-selectable. And what do I do to remove a part from the intesecting parts list?

Thanks in advance for all your assistance.

Regards,
SrG.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top