Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fabrication of 99.5% Alumina of 0.5" thick

Status
Not open for further replies.
sridhar

sridhar

Chemical
Feb 28, 2000
1
What will be the most cost effective way of fabricating 99.5% Alumina plate of 0.5" thick. Size will be approx. 15" x 12". Required Density: > 98%
 
Status
Not open for further replies.

Similar threads

J
  • Question
Calculation of Residual strength of synthetic hawser rope
Replies
0
Views
1K
jayakumaran
J
N
  • Question
Overly of ERCuAl-A2 over low alloy steel
Replies
4
Views
134
Nanda Kishore Kandregula
N
Otibix
  • Locked
  • Question
Shear Strengths of Glass Ceramics 1
Replies
5
Views
929
Otibix
Otibix
dshore
  • Locked
  • Question
Bending of copper bus bar strips 2
Replies
3
Views
665
MintJulep
M
feajob
  • Locked
  • Question
Certainty of Survival of S-N Curves
Replies
3
Views
342
SWComposites
SWComposites

Part and Inventory Search

Sponsor

Back
Top Bottom