Fall protection system - anchor design load 2

[1521projectdr]

Does anyone know OSHA reference section numbers that spells out design load ( I believe it is 5000 pounds minimum load per lug) for fall protection system anchors?

Thanks
Jay

 

[71corvette]

Standards - 29 CFR - 1926.502(d)(15)

The complete section (yes, it is lengthy) can be found at the following link.

http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=STANDARDS&p_id=10758

 

[JJF]

Be careful with fall protection, there is more to it then just the load design, theres' fall geometry, types of lanyards, arresting loads on the unfortunate victim, retreival techniques etc. You should check out

http://www.dbisala.com

for more information.

JJF