fanuc control

[thelastengineer]

Message: any of you guys know how to get a fanuc 15m control to read and execute a one line full circle cut eg on the tosnuc (toshiba )i run a g12/13 g23/22 this runs from the center 45 degree vector in full circle cut and vector off to the center,im not to sure if its a parrameter setting on the fanuc but im sure you can do it ,anybody help me out here

 

[enginebob]

I think this will do it. It's been awhile for me.

X-1.0 ;
G03 I-1.0 ;