Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fanuc OM error

Status
Not open for further replies.
majstr

majstr

Mechanical
Feb 4, 2006
4
0
0
SI
hello,
When I start the servo I have two errors:
401 servo error-VRDY OFF
414 servo error- X axis detect error
Did You have the same problem any time?
Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The 414 error usually means that you have an axis disconnect. This error is very common when a cannon plug comes loose or an axis cable gets cut.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Thierry SEGUI
  • Locked
  • Question
Fanuc system variables
Replies
1
Views
15
enginesrus
enginesrus
Phillip_AE
  • Locked
  • Question
Amada software DR.ABE simulation Error EM 401 S
Replies
0
Views
7
Phillip_AE
Phillip_AE
luthau
  • Locked
  • Question
Z70 Absolute Position Error on M720 unit
Replies
1
Views
9
luthau
luthau
angeldelangel
  • Locked
  • Question
616 ALARM EIL ERROR SENT BY AN MTU DIESEL ENGINE
Replies
0
Views
7
angeldelangel
angeldelangel
woodwood
  • Locked
  • Question
Fanuc G81 Drilling cycle
Replies
3
Views
15
ornerynorsk
ornerynorsk
Back
Top