Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

fasteners thread angle

Status
Not open for further replies.
abdowurth

abdowurth

Mechanical
May 2, 2012
1
We all now that the standard thread angle of a fastener is 60 degrees. I just want to know what will happen to the torque applied, tightening, and other forces, if we reduce this angle?
 
Status
Not open for further replies.

Similar threads

farmerandy7481
  • Locked
  • Question
Effective Tensile Area of Thread 1
Replies
2
Views
39
farmerandy7481
farmerandy7481
fel3
  • Locked
  • Question
F 1554 Headed Anchors vs. Threaded Rod
Replies
0
Views
109
fel3
fel3
Metaljon
  • Locked
  • Question
Structural Angles 2
Replies
6
Views
30
TXStructural
TXStructural
picasa
  • Locked
  • Question
thread strength
Replies
1
Views
21
EdStainless
EdStainless
Raikku
  • Locked
  • Question
Standards for stainless steel fasteners
Replies
1
Views
51
bmoorthy
bmoorthy

Part and Inventory Search

Sponsor

Back
Top Bottom