Saver2008
Mechanical
- Oct 14, 2008
- 112
Hi!
I´m performing some static analysis on SOLIDWORKS SIMULATION but I have the following problem:
1.- The item is a section of a vessel and is going to be only under internal pressure. The problem I have is that if I use ASTM A36 (material precharged in solidworks library) I have results that are credible, however, when I change the material with SA-516-GRADE 60 (I had to add a new material)the results are exagerated. There is a warning about big values in displacements and so on. I let the machine finish the analysis and the displacements are more than 300mm. This only happens with the material I added and not with A36 precharged in solidworks material.
I checked the values of SA-516-60 but I did not find anything wrong....what do you think about it?
Thanks
RS
I´m performing some static analysis on SOLIDWORKS SIMULATION but I have the following problem:
1.- The item is a section of a vessel and is going to be only under internal pressure. The problem I have is that if I use ASTM A36 (material precharged in solidworks library) I have results that are credible, however, when I change the material with SA-516-GRADE 60 (I had to add a new material)the results are exagerated. There is a warning about big values in displacements and so on. I let the machine finish the analysis and the displacements are more than 300mm. This only happens with the material I added and not with A36 precharged in solidworks material.
I checked the values of SA-516-60 but I did not find anything wrong....what do you think about it?
Thanks
RS