Feature Control Frame

[phillpd]

NX 6.0.5.3

I guess it's still not possible to create a Feature Control Frame with a Leader type of Flag on the end face of a cylinder ?

I did try resorting to my NX3 method of using the Simplify Curves option in an expanded view, but without success.

Any suggestions ?

Specialty Engineered Automation (SEA)

http://www.sea4ug.com

a Siemens PLM Solutions Partner

 

[jerry1423]

Insert > feature control frame

 

[phillpd]

Jerry,

That's what I'm using, but I can't select the end face of a cylinder, as it's an arc,

Specialty Engineered Automation (SEA)

http://www.sea4ug.com

a Siemens PLM Solutions Partner

 

[jerry1423]

Oh, I see, as far as I am concerned that is a bit of a problem too.
You can point to it as if it a note, but that may not be your preferred way.
If you have a hidden straight surface, such as on a keyway you can utilize that.
Go in view dependent editing, and make that straight edge something other than hidden and dimension to that.