Features falling off drawings

[jimdogg]

I am using SW2004 sp 2.1. When opening some drawings, it will show the feature having dangling dimensions and/or it will not be there. When I go and open the model the feature is there. I don't even need to rebuild the model. This also happens when the drawing is opened using SW viewer. Also, font size in some annotations is increasing when printed. Are these solidworks faults? Or are my drawings sub standard?

Any susgestions much appriciated

Jimdogg

 

[TheTick]

Do you have multiple configurations of your part? Perhaps the drawing is showing a different configuration.

Due to illness, the part of The Tick will be played by... The Tick.

http://www.EsoxRepublic.com

 

[MadMango]

What OS and graphics card are you using?

Ray Reynolds
"Computers in the future may weigh no more than 1.5 tons."
Popular Mechanics, forecasting the relentless march of science, 1949
Have you read faq731-376 to make the best use of Eng-Tips Forums?

 

[jimdogg]

The Tick.
Thanks will look into that. Have had problems there before.

Madmango.

I think our graphics is more towards the low end so will investigate more. Thanks for the faq link too.

Jimdogg