Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Feed rate in orthogonal machining process

Thread starter Sivareddy D V
Start date May 12, 2017

Status: Not open for further replies.

May 12, 2017

Sivareddy D V

Mechanical

Hi i am new to this abaqus explicit.I have gone through many papers related to variation of output response with feed rate in machining process.But i could not able to find the where we can give feed value in 3D.Please help me in this regard and what is the difference between Feed rate in 2D & 3D Simulation
thanking you