Fellows Taper

[Occupant]

Does anyone know, how to get data on a Fellows taper #1?
All of my handbooks are absolutely silent on the subject.

 

[Timelord]

This has been discussed here before, but unfortunately it appears that no one had an answer.
See:

http://www.eng-tips.com/viewthread.cfm?qid=14408

Timelord

 

[WinstonH]

O,

Fellows Shank cutter tapers:

#1 morse, with 0.4750" Gage dia, by 1.000" long.

#2 morse, with 0.7000" Gage dia, by 1.500" long.

Fellows Short Taper, 1.0625" Gage dia, by 1.500" long.

Fellows Long Taper, 1.0625" Gage dia, by 2.250" long.

All with appopriate drawbar thread in the ends.

IIRC, Ash gear used to have the data in their catalog and also carried a good selection of adapters.

Cheers,

Winston H.