Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

FEMAP as PrePost for LS-DYNA Solver

Thread starter WPZ
Start date May 4, 2014

Status: Not open for further replies.

May 4, 2014

WPZ

Mechanical

I have LS-DYNA solver and I would like to use Femap as the Pre-Post; Is there anybody here who did it?
How is the Femap interface to run LS-DYNA? Any restrition or something like that?
I need to figure out how to do CUTTING SIMULATION (Explicit Mode).

Thank you very much.

Wagner