Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fiberglass Mold Fabrication.

Thread starter joroke
Start date Jun 25, 2004

Status: Not open for further replies.

Jun 25, 2004

joroke

Structural

I work for a water slide company and we are trying to figure out were to have our molds fabricated. The molds are utilized to create fiberglass parts. The molds are usually less then 10' in length and 5' in width.
Any information of possible mold fabricators or experiences would be greatly appreciated.