Do 309 and 309L fall into the category of "austenitic-chromium-nickel", as referenced in UHA 32-2? I would believe so myself, but I am not 100% sure how to determine whether or not a filler falls into that category. Also, what is the best way to determine which of the two is best for the job (410S base metal or otherwise)?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Filler Choice for 410S
- Thread starter QANo1
- Start date
- Status
Similar threads
- Locked
- Question