Fillet modeling on propeller

[sachin46]

Dear all,
I have a model of propeller blade which was created in ANSYS multiphysics.
I have attached image of same with this thread .
I would like to model fillet in between blade and hub with certain radius. As blade is curvature in I can't use the option
extrude area -> along line .
Can anybody know how to model same ?
Thanking you

Regards,
sachin46

 

[meshparts]

Hi,

there is a command in Ansys MAPLD for creating a fillet between two areas. Have you searched the Manual for that?

MESHPARTS
Tuning Your Simulation

http://www.meshparts.de

 

[rahul98]

if you are using WB in DM you have face fillet option