Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Home
Forums
Things
Engineering Computer Programs
Engineering Programs
Autodesk: Mechanical Desktop

fillet

Thread starter medontknow
Start date Jul 29, 2003

Status: Not open for further replies.

Jul 29, 2003

medontknow

Mechanical

Can anyone provide a tip on adding fillets to a part that will require many of them? I worked on a part recently that had several fillets. I was trying to figure out a way make the fillets easier. Some areas were very tight to reach, which required to zoom in on the edge.