In NX is there a way to find the true top and bottom of a hole that is not normal to a surface? I am currently using Vero VISI and there is a "draw axis" function. This will put a circle at the top and bottom of the cylinder that would make the hole. Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Finding true top and bottom of hole
- Thread starter jordan83
- Start date
- Status
Similar threads
