TxBxSx
Structural
- Jun 27, 2011
- 6
I am new to the concept of honeycomb panels and fairly oblivious to how it is usually handled. I am trying to figure out a way to create an aesthetically pleasing edge using aluminum honeycomb panels.
I would like to try and avoid having custom panels made, and would rather just buy full sheets, cut them to size, and finish and fasten the edges. Of course, in the most cost effective way.
Any experienced suggestions would be greatly appreciated.
I would like to try and avoid having custom panels made, and would rather just buy full sheets, cut them to size, and finish and fasten the edges. Of course, in the most cost effective way.
Any experienced suggestions would be greatly appreciated.