Michel1978
Mechanical
- Nov 12, 2008
- 125
I've a very weird problem.
We recently changed from NX5 to NX6 and now my "fit" command doesn't work anymore with some assemblies. Doesn't make any difference if I use the fit from the pull-down or control-F or the fit on my space pilot.
When I do "Fit" my whole assembly disappears from the screen. With end or home I get it back.
But when I click with the RMB anywhere in the screen I can sometimes select a part, so it is seems to be there but I can't see it!!
It's very anoying since it also recalculates the boundaries of the assembly when doing a "fit".
The UGS helpdesk did there best but couldnt find it.
PS. A fit on the same assembly by a colleage just works well!
I use NX5.
Groeten, Michel
A leading Dutch institute in atomic and subatomic physics
We recently changed from NX5 to NX6 and now my "fit" command doesn't work anymore with some assemblies. Doesn't make any difference if I use the fit from the pull-down or control-F or the fit on my space pilot.
When I do "Fit" my whole assembly disappears from the screen. With end or home I get it back.
But when I click with the RMB anywhere in the screen I can sometimes select a part, so it is seems to be there but I can't see it!!
It's very anoying since it also recalculates the boundaries of the assembly when doing a "fit".
The UGS helpdesk did there best but couldnt find it.
PS. A fit on the same assembly by a colleage just works well!
I use NX5.
Groeten, Michel
A leading Dutch institute in atomic and subatomic physics