Fixed Wall Support Singularities

[FEAbeginner1]

Greetings,
I am relatively new to Abaqus CAE. I am trying to model a flat structure using shell elements.
One side of the structure is to be completely fixed.
The analysis is not converging, as I believe the wall support creates singularities?
How can I get the real result of the total reaction at the support?

Much appreciated...

 

[IceBreakerSours]

How do you know singularities are the cause of non-convergence of your model? Check your supports again.

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083