JordonMusser
Mechanical
- Dec 22, 2006
- 40
I have a bunch of approx 40" long 6061 U channels that I need a profile cut out of. I plan to cut slots into a large .25" steel plate and use fixture clamps so all the pieces will be located in relation to each other closely, and so I can do several pieces during one run.
My question is, how hard is it to "index" in the whole sheet? I know how to do it on a mill, but no clue how laser/water tables reference their start position. cost is my biggest concern, as this part MUST be made CHEAP.
My question is, how hard is it to "index" in the whole sheet? I know how to do it on a mill, but no clue how laser/water tables reference their start position. cost is my biggest concern, as this part MUST be made CHEAP.