Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flange Gasketing 1

Status
Not open for further replies.
reesh

reesh

Mechanical
Oct 16, 2001
27
Hi,

I'm trying to evaluate a flange using Bluegard 3000 gaskets at 1/16" thick. I can't find the m and y values for this type of gasket.

Can anyone suggest where I might find this info?

Thanks!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
m=4.2, Y= 3,050 psi
Garlock Engineered Gasket Material Catalogue
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

L
  • Question
ASME B16.5 Flange Hole Chamfering
Replies
7
Views
1K
Compositepro
Compositepro
rajeshnair1977
  • Locked
  • Question
Flange Drilling
Replies
11
Views
291
LittleInch
LittleInch
SSP1987
  • Locked
  • Question
Non standard flange design
Replies
5
Views
180
Cobra17
Cobra17
C
  • Question
ASME VIII-1 Appendix 2 integral flange (Figure 2-4, Sketch 5/6/7) - hub internal to shell boundary permissible? 1
Replies
12
Views
3K
COpressurepipe
C
Skatemav86
  • Locked
  • Question
Flange bolts preload stress: ASME II Part D vs. PCC-1 1
Replies
4
Views
304
TGS4
TGS4

Part and Inventory Search

Sponsor

Back
Top Bottom