Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flange Rigidity

Status
Not open for further replies.
welding1

welding1

Mechanical
Dec 2, 2000
122
Does anybody take any notice of ASME 8 Div 1 Appendix S. It seems odd to me that it is not incorporated in Appendix 2, is there a reason for this?

Many Thanks
John
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Appendix S is non mandatory, and it contains considerations and caveats, not sharp design rules: that's why I think.
prex
motori@xcalcsREMOVE.com
Online tools for structural design
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

L
  • Question
ASME B16.5 Flange Hole Chamfering
Replies
7
Views
1K
Compositepro
Compositepro
rajeshnair1977
  • Locked
  • Question
Flange Drilling
Replies
11
Views
276
LittleInch
LittleInch
SSP1987
  • Locked
  • Question
Non standard flange design
Replies
5
Views
179
Cobra17
Cobra17
C
  • Question
ASME VIII-1 Appendix 2 integral flange (Figure 2-4, Sketch 5/6/7) - hub internal to shell boundary permissible? 1
Replies
12
Views
3K
COpressurepipe
C
Skatemav86
  • Locked
  • Question
Flange bolts preload stress: ASME II Part D vs. PCC-1 1
Replies
4
Views
295
TGS4
TGS4

Part and Inventory Search

Sponsor

Back
Top Bottom