Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flange serration damage

Status
Not open for further replies.
viswam128

viswam128

Mechanical
Dec 11, 2014
1
Hi
Please, instruct on flange face serration damage acceptance table for above 60 inch dia.
Thank you
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Another option, review ASME B16.47, Table 16.
For 50 to 60 inch flange, maximum radial projection which does not exceed the depth of serration, and depth and radial projection, which go deeper than the serration.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Sparky4598
  • Locked
  • Question
Fatigue damage and heat treatment 1
Replies
8
Views
738
MFAMET
MFAMET
thinhtd5591
  • Locked
  • Question
Carbon Equivalent of A105N Flange 5
Replies
8
Views
230
dik
dik
Abu Bakar
  • Locked
  • Question
SS Camlock Installed with CS Threaded Flange
Replies
7
Views
175
EdStainless
EdStainless
1troyg
  • Locked
  • Question
Pipe Fitting & Flange Manufacturer Trademark Cross-Reference
Replies
0
Views
70
1troyg
1troyg
Ratheesh_n
  • Locked
  • Question
Corrosion test for UNS 31254 in fittings vs forged flanges.
Replies
8
Views
379
SJones
SJones

Part and Inventory Search

Sponsor

Back
Top Bottom