Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flanges Vs Drilling of the valves

Status
Not open for further replies.
hyari

hyari

Mechanical
Dec 25, 2014
27
0
0
QA
Hi ,

What is the difference when they mention - FOR EXAMPLE - ( the valve flange according to EN1092-2 & the drilling to DIN 2501-PN 10 )

2ND question , how can i know if the valve is matching with the flange ? shall i check the PN Drilled or what ?


Ahmad
 
Replies continue below

Recommended for you

Sort by date Sort by votes
It's correct. the piping connection is based on the flange dimensions. The drilling of the valve connection per DIN 2501 is to ensure it to match the piping flange which is made per DIN 2501.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Adam1900
  • Locked
  • Question
Potable Water Pipe Valves Fittings Protection in Fillcrete Backfill
Replies
3
Views
20
bimr
bimr
computercameraman
  • Locked
  • Question
Check Valves: Upstream/Downstream Diameter Requirements
Replies
6
Views
32
1503-44
1503-44
eddtan
  • Locked
  • Question
Suction pipe diameter vs lift height
Replies
9
Views
16
LittleInch
LittleInch
ewizz__
  • Locked
  • Question
Determining the 10-year WSEL (water surface elevation) of a micro-bio with a weir
Replies
1
Views
10
bimr
bimr
ChrisPeterson
  • Locked
  • Question
C-900 vs. Ductile Iron
Replies
9
Views
12
hydrae
hydrae
Back
Top