jerubio
Mechanical
- Sep 14, 2014
- 1
thread799-299958
thread799-299958
Dear All,
I would like to do an FSI simulation for a set of flapping wings. I will use a solid domain (Abaqus Standard) and a fluid domain (Abaqus CFD). In the past I've done FSI simulations by developing a solid structural domain, and the developing a CFD domain with a cavity (cut) inside with the exact dimension of the structural part. I plan to use the same approach for this.
Do you have any suggestions on how to construct the mesh for the CFD domain? More specifically what kind of boundary conditions.
thread799-299958
Dear All,
I would like to do an FSI simulation for a set of flapping wings. I will use a solid domain (Abaqus Standard) and a fluid domain (Abaqus CFD). In the past I've done FSI simulations by developing a solid structural domain, and the developing a CFD domain with a cavity (cut) inside with the exact dimension of the structural part. I plan to use the same approach for this.
Do you have any suggestions on how to construct the mesh for the CFD domain? More specifically what kind of boundary conditions.