Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flaring in Stainless Steel 5D Pipe Bends

Status
Not open for further replies.
hirendhara1234

hirendhara1234

Mechanical
May 9, 2009
5

In 10" x Sch 40 SA 403 Type 304L 5D Pipe Bend Flaring is observed at the end portions . Is there any acceptable criteria for Flaring?
 
Status
Not open for further replies.

Similar threads

Jupshaw
  • Locked
  • Question
Request for Manual Inspection Procedures for Tube Bending Assembly with X, Y, and Z Origin Bends&quo
Replies
1
Views
201
r6155
r6155
DMRAO
  • Locked
  • Question
MDMT for ss 316L pipe
Replies
2
Views
582
0707
0707
RogerSAM
  • Question
Repair against Chloride SCC in Tank
Replies
1
Views
174
EdStainless
EdStainless
PetkovStoyan
  • Locked
  • Question
Inspection of keyway in bore
Replies
13
Views
729
geesaman.d
geesaman.d
Tmoose
  • Locked
  • Question
We are having some 8000 lb steel ca
Replies
4
Views
115
MintJulep
M

Part and Inventory Search

Sponsor

Back
Top Bottom