Jan 14, 2015 #1 hirendhara1234 Mechanical May 9, 2009 5 In 10"x Sch 40 5D Pipe bends (Material SA 403 Type 304L ) if flaring is observed at end portions is it acceptable? what is acceptable criteria for flaring?
In 10"x Sch 40 5D Pipe bends (Material SA 403 Type 304L ) if flaring is observed at end portions is it acceptable? what is acceptable criteria for flaring?
Jan 20, 2015 #2 gr2vessels Mechanical Sep 29, 2004 1,971 Look up Table 4 in ASME SA 106 for diameter tolerances. There is not such term as 'acceptable flaring'. Cheers, gr2vessels Upvote 0 Downvote
Look up Table 4 in ASME SA 106 for diameter tolerances. There is not such term as 'acceptable flaring'. Cheers, gr2vessels
