Flat Head Auto-mate

[Keith1029]

Hi All,
I assume that I am just missing something basic. I have been dealing with it for a while now, but it is getting under my skin. I used to have a SW version with toolbox installed and I could drop flat head screws into countersunk holes and get an auto-mate to lock it in place. At some point (I think after 2009 installation) I could do the same thing, except my auto-mate has the wrong orientation. Every time I drop in a countersunk screw it mates upside down and I have to reverse the mate orientation. Has anyone else seen this, or more importantly, solved this?

 

[Updraft]

Before releasing the fastener on the hole hit the Tab key. That changes the mate orientation. Why it doesn't defaul to this orientation I don't know; it is aggravating.

- - -Updraft

 

[Keith1029]

Fantastic! What a reduction in stress level. Thanks.