Flat Pattern Annotation NX10 1

[jerry1423]

Our dimensioning is done based on ISO standards, with a comma (not a decimal pt) in the number.
I would like my flat pattern annotation to be the same way, but it shows up as a decimal pt.
How can I change the decimal pt to a comma in the note ?
I am on NX10

Jerry J.
UGV5-NX11

 

[NutAce]

There is nothing in the ISO standards which says you have to use a comma, or a point, as a delimiter on Technical drawings... With some fonts it does make it more visible however.
Having said that...

In the customer defaults you will find the formulas for the callout. The formula is using a point (3.2) as Decimal delimiter. Change that to a comma.

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX11 / TC11