I would like to make a hydraulic cylinder where the length of the cylinder is driven off of the distance between to axes. The driving axis is built off of a sketch so I can change the "stroke" length of the sketch and it will update my components. I'm not sure if a flexible component can be assembled to an axis and was curious if anyone could help me out. See my attached document that illustrates what I am trying to do. Thanks.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flexible Component Definition using Axis
- Thread starter gpommer1
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question