Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FLOATING POINT ERROR

Thread starter kom23
Start date May 25, 2004

Status: Not open for further replies.

May 25, 2004

kom23

Industrial

i need somebody´s help. i am working on mathcad professional 2001i with the image processing extension pack. i calulate moments (if you know the invariat moments by hu; mathcad command: moment_invariant(matrix)) and so i get very, very small values. like 10^-10 or 10^-25. when i run the program with a picture i get a FLOATING POINT ERROR. perhaps i need to change some settings or something. thank you for your advice