Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flow rate through 03 size hose

Status
Not open for further replies.

ma2mw

Mechanical
Sep 26, 2003
5
US
I am trying to design a special application cleaning hose for a pressure washer. Assuming 4gpm at 1500psi available to my hose. My hose is 6 feet long with a ID of 0.138 inches (smooth bore teflon hose). How can I determine the pressure and flow rate (of water) if the spray tip on the opposite end of my hose has (6) 1/32 inch holes drilled into it? Thanks in advance. I'm trying to increase the fuel efficiency of aircraft turbofan engines. (we need to start saving our fuel).
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top