Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

FLOW VOLUME IN AUTOPIPE

Thread starter mgiani84
Start date Feb 5, 2008

Status: Not open for further replies.

Feb 5, 2008

mgiani84

Mechanical

Hi.. I´m using Autopipe to make a stress analisys. I have to test diferent flow volumes in a system and I don´t know how to enter this data in the software. (for example cubic meter per hour or gallons per hour).

We are changing the piston of a pump and we have to test if the new flow volume is acceptable for the piping instalation from the stress point of view.

thanks in advance

regards,

Miguel