christianroth
Automotive
- Nov 16, 2002
- 53
I'm looking to study the air flow around a automobile and am a little puzzled on how to setup my boundaries.
It seems I can only set an inlet/outlet velocity on a face rather than a plane or a view. Perhaps I can set it on a wall.
Anyone having any tips?
For example how would you model a golf ball, as it would be tough to pick a face.
It seems I can only set an inlet/outlet velocity on a face rather than a plane or a view. Perhaps I can set it on a wall.
Anyone having any tips?
For example how would you model a golf ball, as it would be tough to pick a face.