I have been changing criterion and refinement levels to try and get better resolution around the irregular cell but to no avail. Sometimes it just creates an irregular cell somewhere else. It is on an edge between to faces almost 90deg to apart. Is there something else I should take in to consideration? This particular model meshed fine before updating to SW2007. We are now on SW2007, but still on FloWorks2006.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
FloWorks - how to get rid of irregular cells?
- Thread starter audiv8
- Start date
Similar threads
- Locked
- Question
- Locked
- Question